Connect an Operator over IPsec¶
This guide connects the Ella MOCN host to an operator's security gateway through a route-based IPsec tunnel, using strongSwan.
Prerequisites¶
- Host: Ubuntu Server 26.04, with a certificate and private key signed by a CA the operator trusts.
- Operator's security gateway: its address and its CA certificate.
- Operator's networks: the networks that hold the operator's MMEs, AMFs, S-GWs and UPFs.
1. Install strongSwan¶
sudo apt update
sudo apt install -y strongswan-swanctl charon-systemd
2. Create the xfrm Interface¶
Create one xfrm interface per operator. Set its MTU to the MTU of the interface that reaches the operator's security gateway, minus 100 bytes for IPsec.
Create /etc/systemd/network/50-xfrm-opa.netdev:
[NetDev]
Name=xfrm-opa
Kind=xfrm
MTUBytes=1400
[Xfrm]
InterfaceId=1
Independent=yes
Create /etc/systemd/network/50-xfrm-opa.network, with Ella MOCN's address toward the operator and a route to the operator's networks from that address:
[Match]
Name=xfrm-opa
[Network]
Address=192.0.2.10/32
[Route]
Destination=10.45.0.0/16
PreferredSource=192.0.2.10
Apply the configuration:
sudo networkctl reload
Check that the operator's networks are routed through the xfrm interface:
ip route get 10.45.0.1
3. Configure the Tunnel¶
Install the host's certificate and key, and the operator's CA certificate:
sudo install -m 644 mocn.pem /etc/swanctl/x509/
sudo install -m 600 mocn.key /etc/swanctl/private/
sudo install -m 644 operator-a-ca.pem /etc/swanctl/x509ca/
Create /etc/swanctl/conf.d/operator-a.conf:
connections {
operator-a {
version = 2
local_addrs = 198.51.100.10
remote_addrs = 203.0.113.1
local {
auth = pubkey
certs = mocn.pem
}
remote {
auth = pubkey
id = "CN=segw.operator-a.example"
}
if_id_in = 1
if_id_out = 1
children {
operator-a {
local_ts = 192.0.2.10/32
remote_ts = 10.45.0.0/16
start_action = start
dpd_action = restart
}
}
}
}
local_addrsandremote_addrs: the host's address and the operator's security gateway.remote.id: the identity in the operator's security gateway certificate.local_ts: Ella MOCN's address toward the operator.remote_ts: the operator's networks.if_id_inandif_id_out: theInterfaceIdof the xfrm interface.
4. Start the Tunnel¶
sudo swanctl --load-all
Check that the tunnel is up:
sudo swanctl --list-sas
Then connect the operator. Its MMEs and AMFs are reached through the tunnel.