Skip to content

Enable User-Plane Aggregation

This guide carries an operator's subscriber traffic through Ella MOCN, so the operator sees Ella MOCN's addresses instead of the radios'.

Prerequisites

  • Operator: connected over IPsec, as in Connect an Operator over IPsec, with its S-GWs and UPFs in the networks routed through the tunnel.
  • User-plane interface: the interface of the Ella MOCN host that radios' user traffic arrives on.

Prepare the Host

  1. Create /etc/ella-mocn.nft, with the interface radios' user traffic arrives on, eth1 here:

    table inet ella-mocn
    delete table inet ella-mocn
    
    table inet ella-mocn {
        chain forward {
            type filter hook forward priority filter; policy accept;
            iifname "eth1" drop
            oifname "eth1" drop
            iifname "xfrm-*" oifname "xfrm-*" drop
        }
    }
    
  2. Load it at every boot:

    echo 'include "/etc/ella-mocn.nft"' | sudo tee -a /etc/nftables.conf
    sudo systemctl enable nftables
    
  3. Load it now:

    sudo nft -f /etc/ella-mocn.nft
    

Turn It On in Ella MOCN

  1. In the configuration file, set ran.user_plane.enabled to true, and set ran.user_plane.name to the interface radios' user traffic arrives on:

    ran:
      user_plane:
        enabled: true
        name: eth1
    
  2. Restart Ella MOCN.

Turn It On for an Operator

  1. In Operators, open the operator.
  2. Next to User-Plane Aggregation, click the edit icon.
  3. Turn on User-plane aggregation and click Save.

Check the Operator's User Plane

  1. Check that Status in User Plane is Ready, and that Interface is the operator's xfrm interface.
  2. Ask the operator to accept the Addresses shown in User Plane on its MMEs, AMFs and gateways.